{ "FUNCTIONAL" : [ "Control for up to eight zones of switching for lighting and plug loads", "Control for up to eight zones of 0-10V dimming for LED drivers and fluorescent ballasts", "UL924 emergency-lighting control via contact closure and power loss sense feed terminal", "Demand Response input provided by a power company can enforce a maximum level per circuit while active", "Supports USITT DMX512-A (ANSI E1.11)", "Supports RDM (ANSI E1.20)" ], "MECHANICAL" : [ "Constructed of 16-gauge cold-rolled steel, finished in fine-textured, black powder coat", "Wall-mount installation;", "rated for installation in plenum air space", "Class-1 voltage barrier prevents access to line-voltage wiring with front panel removed", "Optional voltage divider allows for separation of normal and emergency circuits in a single controller where allowed by local codes" ], "ELECTRICAL" : { "100-277V, 50/60Hz power input per circuit with support for pass thru to multiple circuits" : "", "Supports 120V and 277V circuits within the same panel" : "", "20-Amp, fully-rated bi-state latching relay per output" : "", "0-10VDC control rated for up to 100mA sink per output" : "0-10V outputs are fully isolated from ground to 2500V RMS", "Rising clamp screw terminal wiring connections for" : [ "Line-voltage relay power input, output and pass-through with support for 14-8 AWG wire", "Controller power input and UL924 Sense circuit with support for 20-12AWG wire", "Low-voltage 0-10V dimming output per zone with support for 22-16 AWG wire", "Separate normal power sense feed input for UL924 emergency lighting bypass", "UL924 emergency lighting control contact closure input with support for 22-16 AWG wire", "Demand Response contact input with support for 22-16 AWG wire" ], "Demand Response input supports Normally Open (NO) operation" : "", "UL924 contact closure input supports normally open (NO) or normally closed (NC) operation" : "", "Onboard status indicators for controller power, DMX signal, Demand Response input, and UL924 emergency lighting control" : "", "Slide switch configuration for" : [ "UL924 operation (NO/NC)", "UL924 inclusion per circuit (on/off)" ], "UL and cUL LISTED" : "Conforms to UL508, UL2043, UL916 and UL924", "DMX INPUT PORT" : [ "Optically-isolated input from the Mini Panel electronics", "Withstands fault voltages of up to 250VAC", "Integrated DMX/RDM termination" ] }, "CONFIGURATION" : { "Remote configuration available via RDM devices such as" : [ "ETC control console with RDM functionality", "ETC DMX/RDM gateway networked to a device running ETC Net3 Concert software" ], "Manual configuration of the starting DMX address, UL924 bypass, and Demand Response on the controller" : "" }, "THERMAL" : { "Ambient room temperature" : "0 to 50°C", "Ambient humidity" : "5 to 95% non-condensing" } } |